How to Install Cabinet Door Handles

Installing cabinet door handles is a simple and straightforward process that can be completed in just a few steps. Follow these steps to install your cabinet door handles like a pro.

Step 1: Measure and Mark

The first step in installing cabinet door handles is to measure and mark the location where you want the handle to be installed. Use a tape measure to measure the distance between the two screw holes on the back of the handle. Then, use a pencil to mark the center of each screw hole on the cabinet door.

Step 2: Pre-Drill Holes

Using an electric drill, create pilot holes for the screws that will hold the handle in place. Be sure to use a drill bit that is slightly smaller in diameter than the screws you will be using. This will help prevent the wood from splitting when you insert the screws.

Step 3: Attach the Handle

Place the handle over the pre-drilled holes on the cabinet door and insert the screws through the back of the handle and into the pilot holes. Use a screwdriver to tighten the screws until they are snug and the handle is securely attached to the cabinet door.

Step 4: Repeat Steps 1-3

Repeat steps 1-3 for each cabinet door handle you want to install. Be sure to measure and mark each location carefully to ensure that all of your handles are installed at the same height and in the same position.

Step 5: Test the Handles

Once all of your cabinet door handles are installed, test them to make sure they are functioning properly. Open and close each cabinet door to ensure that the handles are securely attached and that they are comfortable to use.

In conclusion, installing cabinet door handles is a quick and easy process that can be completed in just a few simple steps. By following these steps, you can give your cabinets a fresh new look and make them more functional at the same time.