is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

Tools and Supplies to Install Cabinet Latches
1 Drill
2 Drill bits
3 Screwdriver
4 Measuring tape
5 Pencil
6 Cabinet latch template
7 Cabinet latch
8 Screws
9 Level
10 Safety goggles

How to Install Cabinet Latches

Easy Steps for Installing Cabinet Latches: A Beginner's Guide

Installing cabinet latches is a simple process that can be completed in just a few steps. Follow these steps to install cabinet latches in your home:

Step 1: Determine the Location
Before you begin installing your cabinet latches, you need to decide where you want to place them. The location will depend on the type of latch you have and the type of cabinets you have. Typically, cabinet latches are installed on the inside of the cabinet door, near the top of the door.

Step 2: Mark the Location
Once you have determined the location for your cabinet latches, use a pencil to mark the spot where you want to install them. Make sure the marks are level and evenly spaced.

Step 3: Drill the Holes
Using a drill bit that is slightly smaller than the screws that came with your cabinet latches, drill holes into the marked spots. Be careful not to drill too deep and damage the cabinet.

Step 4: Install the Latch
Insert the screws that came with your cabinet latches into the holes you just drilled. Hold the latch in place and use a screwdriver to tighten the screws until the latch is secure.

Step 5: Test the Latch
Once the latch is installed, test it to make sure it is working properly. Open and close the cabinet door to ensure the latch is holding the door securely.

Step 6: Repeat the Process
If you are installing multiple cabinet latches, repeat the process for each one. Make sure each latch is installed in the same location and is level with the others.

In conclusion, installing cabinet latches is a quick and easy process that can be completed in just a few steps. By following these steps, you can ensure your cabinet doors are secure and safe.